Scrap kit.a FTU freebie found Stacy
Cakes blog HERE
'Crazy abouy Garv I can't find her blog anymore.. so
HERE is the scrapkit.
Artwork byİVery Manyhttp://www.verymanytubes.com
License # VMT_Artsyatheart
Mask is from
WSL_Mask162 Put this mask in your mask folder.
Impact /Motion Trail install it into your plugin folder in
#1. Start by opening SC_AG1PP.jpg
Shift + D to duplicate the paper bkg.., close the original.
#2. go to Layers/Load Save Mask/
load mask from disk.. find your mask on the preview window in the
load Mask from Disk window. use the settings below.
this leaves 3 mask layers on the
layer palette Merge/ merge group... you will end up with only ONE
If you get in the habit of naming
your layers on the layer palette it will help you in the future..
#3.Click K on the key board the bounding box will pop
pull out on the nodes to make the mask a lil bigger.
#4. Be sure NOT to pull the mask bigger than the
window... where it goes over the edges.
#5. Open SC_CAGHeart5.png either copy and paste it to
your working image with the mask on it..
#6. OR on the layer palette click, hold
and drag the glitter heart's layer over to your working image
#7. Apply the motion trail to the glitter heart.. use
the settings below. Sharpen once
#8. Copy and paste the element SC_CAGCircles1 .png on
to your working image Apply a 3d drop shadow to it.
# 9. Copy and paste the tube your going to use now to
working image. resize 82% Sharpen once.
#10. Open element SC_CAGHeart3.png resize 82%
Drag the beaded heart layer below the girl tube
layer. Apply a 3D drop shadow on the hearts.
#11. Open element SC_CAGStar1.png copy
and paste it to your working image.Apply the 3D drop shadow
#12.Open element Bow1.png and copy and paste it to
your working image.
#13. Duplicate your mask layer.. move one to top
right the other bottom left
when you get what elements you want on your tag..
merge visible layers... Save as a PNG
I hope you enjoyed the tutorial
Toodles till next time!